Installation guide for the PinLED Display-Set 10001

Now we want to show how easy installation can be....if you have any further questions - please let us know.... Support .
If you follow the steps the installation is very easy and safe.

    1. Unplug the mains plug.

    2. Open the Backbox.

    3. Put the Display / Speaker Panel on the playfield cover glass.

    4. Disconnect the cables from the original display.

    5. Remove the four screws of the old display. You will need them later to mount the new display.

    6. Remove the old display.

    7. Get the new PinLED Display into a suitable position.

    8. Take the four spacers which are included in the PinLED Display-Set into a suitable position.

    9. Mount the display with the four screws.

    10. Connect the cables from the system 11 board to the new display. It is not possible to mix them up! The red wire on the flat cable is then on the left of the new PinLED Display board (Pin 1) and on the system 11 board to the right (Pin 1).

    11. Remove the high voltage fuses on the power supply board. There are one or two fuses depending on your board! This is only to be on the safe side. The new displays will also work with installed fuses. But the high voltage is not any longer in use after the conversion to PinLED Displays.

    12. Build in the Display / Speaker Panel.

    13. Install the Backglass again.

    14. Connect the mains plug.

    15. That's it! Switch on the pinball and enjoy playing in new dimensions.....

     

 

In the following pictures you can see some of the points above.

Point 4:


Disconnect the cables from the original display.
   

Point 9:


Mount the display with the four screws.

Point 10:


Connect the cables from the system 11 board to the new display.

Point 11:


Remove the fuses!

Points 12 - 15:
ready to go....