Fitting instructions for the PinLED Displays 30001 and 30003
Now we want to show how easy installation can be....if you have any further questions - please let us know.... Support .
If you follow the steps the installation is very easy and safe.
-
Assemble the PinLED Display.......
-
The set contains all the parts you need. You will find a Controller Board and a LED Display Board. The are also two litte brackets and four screws and spacers in the set included.
-
The bracket has two different legs. One is shorter than the other one!
-
Mount the longer legs of both brackets to the LED Display Board.
-
Connect the LED Display Board to the Controller Board (90° angle)
-
Mount the shorter leg of the brackets to the Controller Board.
-
Unplug the mains plug.
-
Remove the Backglass and open the Backbox.
-
Disconnect the cables from the original display.
-
Remove the old display.
-
Get the new PinLED Display into a suitable position.
-
Connect the cables to the new PinLED Display. It is not possible to mix them up!
-
Close the Backbox and reinstall the Backglass.
-
Plug in the mains plug.
-
Switch on the pinball machine and enjoy your new PinLED Display!
In the following pictures you can see some of the points above.
Point 1 and 2:
Assemble the PinLED Display
Point 3:
The two different legs....
Point 3:
The two different legs....
Point 4:
Mount the longer legs of both brackets to the LED Display Board.
Point 4:
Mount the longer legs of both brackets to the LED Display Board.
Connect the LED Display Board to the Controller Board (90° angle)
Mount the shorter leg of the brackets to the Controller Board.
Point 9:
Disconnect the cables from the original display.
Point 10:
Remove the old display.
Point 11:
Get the new PinLED Display into a suitable position
Point 12:
Connect the cables to the new PinLED Display. It is not possible to mix them up!