PinLED Display-Set 10003

T

he PinLED Display board 10003 contains the control electronics. The board is fully compatible with the control signals of the Data East main board. It uses the same plugs and pin allocations as the original Data East board. No conversion will be necessary. The conversion of the new board is "plug and play". It will take only five minutes. Simply take the old one out and put the new one in. Remove the high voltage fuses on the Power Supply Assembly, that's it! Ready to use! A detailed description is included in every display set. With this installation guide it is even possible for "lay" people to change the display sets.

T

he PinLED Display-Set 10003 is for use in the following Data East- pinballs:  The Simpsons, Phantom of the Opera, ABC Monday Night Football, Robocop, Back to the Future.
Please note that the PinLED Display-Set 10003 fits only the pinball machines from Data East.

T

echnical Notes:
The consistent brilliance of the PinLED Displays make for excellent viewing under all lighting conditions, even bright daylight.
The display board uses only the 5 V voltage from the Power Supply Assembly. Power consumption of the PinLED Display board with all digits on is only 800mA. This additional power will be delivered by the Power Supply Assembly without any problems. The control transistor 2N6057 is designed for 12A, but under normal conditions this high amount of current will not be consumed by the pinball machine (2.5 to 3 A is normal).
A detailed instruction sheet is included for installation.
Please note our Warranty Provisions!

go back