PinLED Display-Set 10007

T

he PinLED Display board 10007 contains the control electronics. The board is fully compatible with the control signals of the WPC-89 main board. It uses the same plugs and pin allocations as the original Williams board. No conversion will be necessary. The conversion of the new board will be very easy. It is "plug and play" and takes only five minutes (see installation guide). Simply take the old one out and put the new one in. That's it! Ready to use! A detailed description is included in every display set. With this installation guide it is even possible for "lay" people to change the display set.

T

he PinLED Display-Set 10007 is for use in the following WILLIAMS- pinballs: The Machine, Funhouse (both WPC-89).
Please note that the PinLED Display-Set 10007 fits only the pinball machines that have the WPC-89 CPU-Mainboard.

T

echnical Notes:
The consistent brilliance of the PinLED Displays make for excellent viewing under all lighting conditions, even bright daylight.
The PinLED Display-Set 10007 has its own 5 Volt Power Supply. This was necessary because the 5 Volt built in Power Supply of the WPC-Driver Board is not strong enough.
A detailed instruction sheet is included for installation.
Please note our Warranty Provisions!

go back