PinLED Display-Set 10015

The following items are included in the PinLED Display set:

T

he Model number 10015 PinLED Controller board contains the display driver electronics. The board is fully compatible with the control signals of the system Williams System 11 and Data East main computer boards. It uses the same male and female connectors as the original Williams and Data East boards. No conversion will be necessary.  Installation is "plug and play" and takes only five minutes (see installation guide). For your safety Remove the high voltage fuses on the Power Supply Assembly.  A detailed description is included in every display set.

T

he Model number 10015 is for use in the following WILLIAMS and Data East pinballs: High Speed, Pinbot, Grand Lizard, Road Kings and Laser War.

!!! CAUTION !!!
Please note that you cannot mix the new PinLED Displays with your old Plasma glass tube Displays.This destroys the LED-Displays immediately!
The Set includes a new Controller Board (required) that replaces the old one.
Everyone can imagine what happens if you connect a 5 Volt display to the normal high voltage of 100 Volts

T

echnical Notes:
The consistent brilliance of the PinLED Displays make for excellent viewing under all lighting conditions, even bright daylight.
The display board uses only the 5 V voltage from the Power Supply Assembly. Power consumption of the display board with all digits on is only 800mA. This additional power will be delivered by the Power Supply Assembly without any problems. The control transistor 2N6057 is designed for 12A, but under normal conditions this high amount of current will not be used in the pinball machine (2.5 to 3 A is normal).
A detailed instruction sheet is included for installation.
Please note our Warranty Provisions!

go back




Copyright © 2004 by A. Förster & J. Jakobi GbR. - Designed & programmed by EDV-Service Anstatt