PinLED Display-Set 10016

T

he PinLED Display-Set 10016 contains the displays, the bulbs for the back light and  the display driver electronics. The board is fully compatible with the control signals of the system Williams System 11. It uses the same connectors as the original Williams board. No conversion will be necessary.  Installation is "plug and play" and takes only five minutes (see installation guide). For your safety Remove the high voltage fuses on the Power Supply Assembly.

T

he Model number 10016 is for use in the following WILLIAMS pinballs: Banzai Run.

The lower display row is made with alphanumeric segments. These are controlled like the original and they only display numeric characters. This is because a second development of numeric character segments is too expensive. This would result in a higher price for each set.

T

echnical Notes:
The consistent brilliance of the PinLED Displays make for excellent viewing under all lighting conditions, even bright daylight.
The display board uses only the 5 V voltage from the Power Supply Assembly. Power consumption of the display board with all digits on is only 800mA. This additional power will be delivered by the Power Supply Assembly without any problems. The control transistor 2N6057 is designed for 12A, but under normal conditions this high amount of current will not be used in the pinball machine (2.5 to 3 A is normal).
A detailed instruction sheet is included for installation.
Please note our Warranty Provisions!

go back