PinLED Display-Set 20002
128x32 PinLED Dotmatrix Display for Williams/Bally, Data East/SEGA/Stern and Gottlieb

The PinLED Display 20002 combine long lifetime and reliability for your Dot Matrix Display Pinball. It is the right replacement for the hard to repair original glass tube display. Who ever tried to change a broken glass tube know what I mean... The PinLED Display shows the different brightness steps and contrast levels like the original glass tube display. The measurement of the LED viewing area is 80x320mm. This is the same as the lighting dot area in the original glass tube (the original glass tube is a little bit larger in its dimension, but the viewing area is 80x322mm).

The PinLED Display-Set 20002 is usable in the following pinballs:

  • All Bally Dot Matrix pinballs

  • All Williams Dot Matrix pinballs

  • All Data East Dot Matrix pinballs (16x128 look at 20001)

  • All SEGA Dot Matrix pinballs

  • All Stern Dot Matrix pinballs

  • All Gottlieb Dot Matrix pinballs

 

The PinLED displays mark themselves with a good brightness. It's comply to the original glass tube display so that you can see what's going on on the display even in bright areas. The PinLED display has its own power supply. This switched power supply deliver the needed +5VDC voltage. The power consumption of the PinLED display in display test with all dots on is approximate 1A. The own power supply is necessary because the Bally/Williams driver boards with their +5V regulator can't drive this additional power load (the regulator is too weak). The PinLED Display is "Plug and Play", so that the installation is very easy. It uses the same mounting wholes like the original glass tube display does. The installation takes about 5 minutes! This isn't a problem even for non electronics.

You will find an exact installation guide on our support page.
Please note our Warranty Provisions!

go back