PinLED Display-Set 30007
For all Bally and Stern Pinballs built between 1980 and 1985

T

he PinLED Display-Set 30007 is the right replacement  for defective original plasma glass tube displays. The PinLED Display has a very long lifetime and fits exactly. It has the same measurements as the original plasma glass tube display units. The PinLED Display-Set 30007 consist of  four 30003 PinLED Displays and one 30001 PinLED Display.

T

he PinLED Display 30007 can be used in all Bally and Stern Pinballs built between 1980 and 1985.
The installation is very easy and simple. We use the same pin allocations as the original display. You can't mix it up! No conversion will be necessary.  Installation is "plug and play" and takes only five minutes (see installation guide).

T

echnical Notes:
The consistent brilliance of the PinLED Displays make for excellent viewing under all lighting conditions, even bright daylight. The PinLED Display 30007 uses only the 5 V voltage from the Power Supply Assembly. Power consumption of the PinLED Display with all digits on is only app. 1A. This additional power will be delivered by the Power Supply Assembly without any problems. The voltage regulator LM323K is designed for 3A, but under normal conditions this high amount of current won't be used in the pinball machine (1 to 1.3A is normal with normal plasma glass tube displays). The additional amount of current isn't critical because even if you have built in five PinLED Displays it will rise up to approx. 2 to 2.3A.

Please note our Warranty Provisions!

go back