 |
Point 2: |
 |
Point 3: |
 |
Point 4: |
 |
Point 9: |
 |
Point 9: |
 |
Point 9: |
 |
Point 10: |
 |
Point 10: |
 |
Points 12 - 15: |
Installation guide for the PinLED Display-Set 10011
N
ow we want to show how easy installation can be....if you have
any further questions - please let us know.... Support
.
If you follow the steps the installation is very easy and safe.
Unplug the mains plug.
Open the Backbox.
Put the Display / Speaker Panel on the playfield cover glass.
Disconnect the cables from the original display.
Remove the four screws of the old display. You will need them later on to mount the new display.
Remove the old display.
Get the new PinLED Display into a suitable position.
Mount the PinLED Display with the four screws.
Connect the cables from the system 11 board to the new display. It is not possible to mix them up! The red wire on the flat cable is then on the left of the new PinLED Display board (Pin 1) and on the system 11 board to the right (Pin 1).
Remove the high voltage fuses on the power supply board. There are one or two fuses depending on you board! This is only to be on the safe side. The new displays will also work with installed fuses. But the high voltage is no longer in use after the conversion to PinLED Displays.
Build in the Display / Speaker Panel.
Install the Backglass again.
Connect the mains plug.
That's it! Switch on the pinball and enjoy playing in new dimensions...
In the following pictures you can see some of the points above.
|
Point 2: |
|
Point 3: |
|
Point 4: |
|
Point 9: |
|
Point 9: |
|
Point 9: |
|
Point 10: |
|
Point 10: |
|
Points 12 - 15: |