Installation guide for the PinLED Display-Set 10015

H

Now we want to show how easy installation can be....if you have any further questions - please let us know... Support
If you follow the steps the installation is very easy and safe.

1. Unplug the mains plug.

2. Open the Backbox.

3. Disconnect the cables from the original displays.

4. Remove the old displays.

5. Remove the old Controller board.

6. Get the new PinLED Display into a suitable position.

7. Get the new PinLED Display Controller board into suitable position.

8. Connect the cables from the system 11 board to the new PinLED Display Controller board. It is not possible to mix them up!  The red wire of the flat cable shows on the new PinLED Display Controller board upwards  (Pin 1) and on the system 11 board to the right (Pin 1).

9. Connect the five PinLED Displays with the flat cables to the PinLED Controller board. Check also Pin1 on each connector!

10. Remove the high voltage fuses on the power supply board. There are one or two fuses depending on you board! This is only to be on the safe side. The new displays will also work with installed fuses. But the high voltage is no longer in use after the conversion to PinLED Displays.

11. Close the Backbox.

12. Install the Backglass again.

13. Connect the mains plug.

14. That's it! Switch on the pinball and enjoy playing in new dimensions.....

In the following pictures you can see some of the points above.

	Point 4: Remove the old displays.
	Point 5: Get the new PinLED Display into a suitable position.
	Point 6: Get the new PinLED Display Controller board into a suitable position.
	Point 7: Connect the cables from the system 11 board to the new PinLED Display Controller board. It is not possible to mix them up! The red wire of the flat cable shows on the new PinLED Display Controller board upwards  (Pin 1) and on the system 11 board to the right (Pin 1).
	Point 7: Connect the five PinLED Displays with the flat cables to the PinLED Controller board. Check also Pin1 on each connector!
	Point 8: Remove the high voltage fuses on the power supply board!
	Point 8: Remove the high voltage fuses on the power supply board!
	Points 12 - 15: That's it! Switch on the pinball and enjoy playing in new dimensions.....