Installation guide for the PinLED Display-Set 10017

N

ow we want to show how easy installation can be....if you have any further questions - please let us know.... Support .
If you follow the steps the installation is very easy and safe.

1. Unplug the mains plug.

2. Remove the Backglass and store it in a safe place.

3. Remove the bracket (located between the two Displays). You don't need it any more.

4. Disconnect the cables from the original display.

5. Remove the old display. Push the ends of the mounting bracket together and pull the old displays out.

6. Push the new PinLED Display into the mounting brackets.

7. Connect the cables from the system 11 board to the new display. It is not possible to mix them up! The red wire on the flat cable is then on the left of the new PinLED Display board (Pin 1) and on the system 11 board to the right (Pin 1).

8. Remove the high voltage fuses on the power supply board. There are one or two fuses depending on you board! This is only to be on the safe side. The new displays will also work with installed fuses. But the high voltage is no longer in use after the conversion to PinLED Displays.

9. Install the Backglass again.

10. Connect the mains plug.

11. That's it! Switch on the pinball and enjoy playing in new dimensions...

In the following pictures you can see some of the points above.

	Punkt 3: Remove the bracket.
	Punkt 3 und 4: Remove the bracket and disconnect the cables from the original display.
	Punkt 5: Remove the old display.
	Punkt 6: Push the new PinLED Display into the mounting brackets.
	Punkt 6: Push the new PinLED Display into the mounting brackets.
	Punkt 6: Push the new PinLED Display into the mounting brackets.
	Punkt 8: Remove the fuses!
	Punkte 10 und 11: Switch the pinball machine on. Ready to go...