Installation guide for the PinLED Fliptronic I+II Board 10032

N

ow we want to show how easy installation can be....if you have any further questions - please let us know.... Support

1. Unplug the mains plug.

2. Open the Backbox.

3. The Fliptronic Board is located in the upper left corner of the Backbox.

4. Disconnect the cables from the original Fliptronic Board.

5. Loosen the six mounting screws.

6. Remove the old board.

7. Get the new PinLED Fliptronic I+II Board into a suitable position

8. Fasten the six screws again.

9. Connect the cables to the PinLED Fliptronic I+II Board. It is not possible to mix them up! The red wird of the flat cable shows to the left.

10. Connect the mains plug.

11. Switch on the pinball machine. The four red LEDs near the four fuses will light up and show that the fuses are ok.

12. Install the Backglass again.

13. That's it! Enjoy playing .....

On the following pictures you can see each point of installation.

	Point 3: The Fliptronic Board is located in the upper leftt corner of the Backbox.
	Point 4: Disconnect the cables from the original Fliptronic Board.
	Point 7: Get the new PinLED Fliptronic I+II Board into a suitable position.
	Point 9: Connect the cables to the PinLED Fliptronic I+II Board.
	Point 11: The four red LEDs near the four fuses will light up.