Fitting instructions for the PinLED Displays 30001 and 30003
N
ow we want to show how easy installation can be....if you have
any further questions - please let us know.... Support
.
If you follow the steps the installation is very easy and safe.
-
Assemble the PinLED Display.......
-
The set contains all the parts you need. You
will find a Controller Board and a LED Display Board. The are also two litte
brackets and four screws and spacers in the set included.
-
The bracket has two different legs. One is
shorter than the other one!
-
Mount the longer legs of both brackets to the
LED Display Board.
-
Connect the LED Display Board to the Controller
Board (90° angle)
-
Mount the shorter leg of the brackets to the
Controller Board.
-
Unplug the mains plug.
-
Remove the Backglass and open the Backbox.
-
Disconnect the cables from the original display.
-
Remove the old display.
-
Get the new PinLED Display into a suitable position.
-
Connect the cables to the new PinLED Display. It
is not possible to mix them up!
-
Close the Backbox and reinstall the Backglass.
-
Plug in the mains plug.
-
Switch on the pinball machine and enjoy your new PinLED
Display!
In the following pictures you can see some of the points above.
 |
Point 1 and 2: Assemble the PinLED Display |
 |
Point 3: The two different legs.... |
 |
Point 3: The two different legs.... |
 |
Point 4: Mount the longer legs of both brackets to the
LED Display Board. |
 |
Point 4: Mount the longer legs of both brackets to the
LED Display Board. |
 |
Point 5: Connect the LED Display Board to the Controller
Board (90° angle) |
 |
Point 6: Mount the shorter leg of the brackets to the
Controller Board. |
 |
Point 9:
Disconnect the cables from the original display. |
 |
Point 10:
Remove the old display. |
 |
Point 11:
Get the new PinLED Display into a suitable position |
 |
Point 12:
Connect the cables to the new PinLED Display. It is
not possible to mix them up! |
If you want to use our PinLED displays 30003 in a Stern
game you have to change one pin (for the 7th digit) of the main connector. Stern
pinballs are using pin 11 for the 7th digit and our PinLED displays are using
pin 12. So you have to change the wire from pin 11 to pin 12 of the main
connector and the 7th digit will light up correctly.
go back